Replacement rubber feet for DJI Mavic PRO
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Had an unintended sudden deceleration and lost one of the rubber feet in the back of my Mavic Pro. As I attach larger…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 349
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Had an unintended sudden deceleration and lost one of the rubber feet in the back of my Mavic Pro. As I attach larger legs there I needed a replacement. However, DJI doesn't make these available at this point in time outside of repair. So I eyeballed the dimensions as good as I could and printed these in Ninjatek Cheetah that I had around. Little bit softer compared to the originals but this filament is very tough.
Empiricus@Dremomys
Print Settings
Printer:
Monoprice Ultimate
Rafts:
No
Yes
Resolution:
0.150 mm
100
Notes:
Ninjatek Cheetah, 80C PEI Bed, 220C, Fan 40%, extrusion 0.9
Category: Replacement Parts