WLED Controller Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case intended to house a D1 Mini or D1 Mini Pro for running WLED.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 958
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a case intended to house a D1 Mini or D1 Mini Pro microcontroller, for running WLED to control individually addressable LED strips.
It is designed to house the D1 on a custom PCB, which also includes a voltage regulator and level converter to shift the LED control signal to 5V. A hole is included for a 5.5/2.5mm barrel socket for power, and a slot and strain relief for a 3 core cable with a JST connector on it (which are not panel mountable unfortunately).
Components required:
- D1 Mini Pro
- Voltage regulator
- Level shifter
- M2x5 self tapping screws (4 off)
- M2x15 self tapping screw (4 off)
- 5.5/2.5mm barrel socket
- JST connector (only the male is actually required)
- Custom PCB (this will need to be ordered through JLCPCB or similar)
Assembly should be straight forward; two points of note:
- You will need to adjust the regulator to supply 5V. This requires cutting the track at the end of the voltage selector pads to disable the variable output pot, and adding a blob of solder to join the 5V pads together. See the photo on Paul's Amazon review for the regulator if you're not sure.
- Power should be supplied directly from the barrel socket to the JST connector, as well as to the PCB.
If you want to modify the case, you can do so in Onshape.