9barista Basket Cap mold
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printable 2-part 9barista basket cap mold
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 204
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Printable 2-part 9barista basket cap mold.
Allows making a suitable silicone replacement for the custom basket cap used by the 9barista. Not cost effective, but definitely satisfying ;)
Optimized for a 0.4mm nozzle, 0.15 layer height. Use PLA along with food-grade silicone.
I used shore 30A on mine, and feels just a tad softer than the original while still being perfectly functional. The original is probably in the 35-40A range.
I didn't use any special equipment:
- print both parts accurately: your result is only as good as your mold
- pour 14g of silicone on “mold b”, filling it just below the rim
- delicately put “mold a” on top with a corner first, then level gently to avoid bubbles
- push down gently but continuously until silicone starts pouring from the top overflow hole
- align the top by rotating until the vertical side lines are aligned
- clamp hard until cured
If the mold has been clamped down correctly there will be very little cleanup to do on the seam lines. Rip off easily the excess using rubber gloves.