1 / 5

PizzaBox Controller for X-Carve 500mmx500mm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

drandolph

@drandolph_171235

I couldn't wait for the new X-Controller to come out so I made a laser cut case for my X-Carve electronics and I added…

Ocena: 0 / 5
Polubienia: 2
Pobrania: 9
Wydruki: 0
Wyświetlenia: 176
Oceny: 0

Aktualizacja u źródła: 12 kwi 2022

Informacje o modelu

Źródło: Printables
Kategoria: Tools
Licencja: Creative Commons — Attribution — Noncommercial

Szczegóły Pliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (4)

I couldn't wait for the new X-Controller to come out so I made a laser cut case for my X-Carve electronics and I added a lot of the options to the base. The relay is internal and has two plugs with separate switches which allows each one to either be on/off or relay. There is an E-Stop and the start/hold/reset buttons are there. I also moved all the connections to the side and put the control switches on the front.

This is my new alternative. I like the idea of it being underneath my machine so it takes up the least amount of table space now. The other reason for the change is I wanted more space for the electronics. It was getting way too crowded in the other one and now there is plenty of wires and air moving around.

Category: Tools

Tagi

thingiverse