Magnetic Riser/Tower for Tundra Labs Super Wireless Dongle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Model intended to better position the dongle, so its not near the metal of the case improves reception and line of sight
- Ocena
- 5 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 1
- Wyświetlenia
- 114
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Share Alike
I made this model since I dont have a good position in my room for the dongle, my controllers kept flying away due to poor reception. It has not happened since I placed it on the riser.
Instructions
Place the included extension on the riser, make sure the logo of Thundra Labs faces your play area for better reception.
Assembly
Place the optional stabilizer on any of the hexagons. Done.
Materials
> For materials you will need a 20mm x 3mm neodymium magnet. I didnt glue it since its very strong, but you can to improve stability.
Printing
> Supports are required but very easy to clean.
> Printed at a .20mm layer height, with Creality Hyper PLA.
> You will need to reposition the stabilizer on the flat face, I also used supports on the stabilizer but it might not be needed with proper cooling.
Feel free to remix maybe into something that requires no magnet. This was just a very specific thing for my setup but I felt could benefit others. F3D files included.