1 / 4
Vaccum nozzle to clean AEG Ökokombi Washer/Dryer's filter — zdjęcie 1
1 / 4

Vaccum nozzle to clean AEG Ökokombi Washer/Dryer's filter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

AEG Ökokombi Washer/Dryer clogs at hard-to-reach place requiring service. Clean yourself with thi vacuum cleaner nozzle.

Ocena
5 / 5
Polubienia
15
Pobrania
83
Wydruki
0
Wyświetlenia
922
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

Clothes in dirty, clothes out dry and clean, guilt free

The AEG Ökokombi Washer/Dryer machine is truly a unique, absolutely wonderful device: Literally no one else was crazy enough to cram a full washer and a full heat pump dryer into one machine.

Regular washer/dryers not only use extreme amounts of electricity, they also use over a hundred liters of water to dry a few kilos of clothes. They're hugely wasteful, it was completely out of the question for me to use one. With the Ökokombi on the other hand, I can just dump my clothes in it and they come out dry and uses like 50 cents worth of juice, which is really very little.

But it breaks down a lot

But it's also wildly annoying- the lint filter ends in a tube junction way inside the machine, and that things clogs. Like, all the time. Like every few months frequently, and then you put your clothes in dirty and they come out moist and gross. Not good.

The 3D printed fix

After two service visits for a clogged tube inside the dryer I realized if I want to keep using this thing I better figure out how to work around that one design flaw: Hence, the extra skinny, extra long vacuum cleaner nozzle.

How to print

This print requires a 350mm build volume.

The STL file parametric and can be adapted to your vacuum cleaner nozzle.

First find out if your vacuum cleaner nozzle connects to the outside or the inside of the vacuum's tube. Specify ‘outer’ in the dropdown if you are going to stick this nozzle into your vacuum cleaner, and specify ‘inner’ if you are going to stick a tube from the vacuum cleaner into the nozzle. Then measure with a caliper and specify the diameter. The 1.75mm wall width is fine for my ABS but you might want to make them a bit thicker for PLA.

Use superglue (or acetone for ABS) to fuse the parts together to form the long, thin nozzle.

There is a 5mm high test ring in the file you can print to check the fit before printing the whole thing.

I use a Dyson V-15 cleaner, which is a snug 35mm ‘outer’ fit with no clearance. There is an STL file for this dryer attached as well. Feel free to share other models and configurations in the comments.
 

Tagi