Fiberglass rod ends for Rostock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Using 5/16 Fiberglass rods from Tap Plastics I modified the Rostock Rod end's to fit inside and bond with Epoxy.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 141
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Using 5/16 Fiberglass rods from Tap Plastics I modified the Rostock Rod end's to fit inside and bond with Epoxy.
Instructions
Get some 5/16 Fiberglass rod.
http://www.tapplastics.com/product/plastics/plastic\_rods\_tubes\_shapes/fiberglass\_rod/159
Then some plastic epoxy (or similar)
http://www.homedepot.com/buy/loctite-085-fl-oz-plastic-epoxy-1360788.html#.UN-0HHfNl8E
The shafts are tapered to make a snug fit and allow a place for the epoxy to bond without squeezing out.
The box at the end of the shaft is a support element to keep the shaft center. Just snip them off.
Cut rod to size, apply epoxy inside rod, insert ends, let set, enjoy!
I printed mine in ABS but because of the tapered shafts PLA should work just as well.
Category: 3D Printer Parts