Thing-O-Matic Hood kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Along the same line as my Replicator hood kit I've now made a ToM version. This helps keep the heat in and prevent…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 199
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Along the same line as my Replicator hood kit I've now made a ToM version. This helps keep the heat in and prevent drafts from messing up your prints. It has a long gap down the center to allow air to escape and allow filament in and out. I also set the height to 6" which is plenty of room no matter what extruder your rocking on your ToM.
On the hood you will notice a 1" square hole in each corner. These are there for anything you may want to add. For example a filament brush or guide.
If you don't have access to a laser cutter let me know and we can work something out.
Instructions
Cut the parts from 3mm (1/8") acrylic.
This design can be cut on a laser cutter with a 12"x12" or larger cutting area.
You will need the following hardware.
4 - M3 22mm Bolts (McMaster #91292A801 50 pack)
16 - M4 12mm Bolts (McMaster #90116A209 50 pack)
16 - M4 Nuts (McMaster #94150A335 50 pack)
24 - #8 Washers (McMaster #90126A512 100 pack)
14 - M3 12mm Bolts (McMaster #95836A211 50 pack)
18 - M3 Nuts (McMaster #98676A100 100 pack)
6 sheets at 20"x12" worth of acrylic at 3mm Thick
Hood assembly instructions:
1 Attach the “hood back†to the “hood sides†with 4 - M3 12mm bolts and nuts
2 Attach the “hood top†panels with 4 - M3 12mm bolts and nuts (there will be a gap running down the center)
3 Attach the “hood front†panel with 6 - M3 12mm bolts and nuts
The hood will rest on top and has a lip to prevent sliding around. You will notice 4 - 1†holes on the corner on the hood. This was to allow for people to make creative 3D objects to and have a place to mount them.
Side panels assembly instructions:
Use 4 - M4 12mm nuts and bolts and 8- #8 Washers to pinch the side and back panel into place.
If your ToM came with a fan port on the left side then use the Fan cover and 4 - M4 Nuts/Bolts
Front panel assembly instructions:
Remove the existing 4 bolts from the front of the ToM
Place the spacer and then the front clip
Use 4 - M3 22mm nuts and bolts to replace the 4 on each side of the ToM
The front panel will slide behind the front clips and rest on the existing wood squares.
Category: 3D Printer Parts