iPhone Magsafe Continuity Camera Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
iPhone mount for using the Continuity Camera with AppleTV
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 289
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution
A simple design for using an iPhone horizontally with FaceTime and Continuity Camera with an AppleTV.
I found these Magsafe adhesive mounts and designed around them: https://amzn.to/3VbKSCY
I expect that there will be many similar variants of these mounts available.
The model has a very slight indentation to assist in properly aligning the adhesive mount on the print. It should work with just about any iPhone except the SE which is significantly smaller (feedback appreciated).
It's not structural so printing with the defaults should be fine. I used Copperfill filament for both the look and the additional weight to stabilize it. You might want to bump up the infill for additional weight in the base.