Dishwasher knob for DFN05X10S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After the control knob of my Beko dishwasher broke, I made this non genuine replacement part for the DFN05X10S
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 62
- Wydruki
- 1
- Wyświetlenia
- 222
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- GNU General Public License v2.0
After the control knob of my Beko dishwasher broke in my fingers, I made this non genuine replacement part for the DFN05X10S dishwasher.
Fits and works well.
I printed with supports as it was my default profile, but don't think they are necessary as they are only in the finger grips cut-outs which are quite small.
Printed with three walls to add strength to the sleeve making it less likely to break with the rotation applied in normal use.
After printing and before fitting
To get this to fit I intentionally made it to be a tight fit. It is actually that tight a fit that to make it go on, boil a kettle and run some boiling water onto the sleeve where it slides over the switch cam, turny bit.
Make sure you don't burn/scald yourself as I did this pour over, wait a few seconds, tip the water out three times to soften the sleeve a little. After this it pushed on fairly easily and then cooled quickly to fit perfectly.