TradRack Motor Mount with Rail Clearance
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lower Motor Mount of the TradRack to clear the linear rail.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 523
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
While TradRack is set up to allow any length linear rail and aluminum extrusion the extra length of it will all need to run out from under the Idler Pulley Mount as the Lower Motor Mount is set up to butt the rail against. I wanted to center all of my gates on my extrusion but I also wanted a rail nearly the same size as my extrusion for future expansion.
These are remixed from the H Carriage versions, it is not compatible with the C Carriage.
I made two versions. The first matches the clearance with the Idler Pulley Mount (idler_pulley_matched) but I found this left the top of the mount too thin for my liking. It printed fine and once the upper mount is added I didn't notice any above average flex. But I created a second version that brings the clearances down some which thickens up the mount and makes it sturdier. The only downside I could possible see from this is the rail stop might not fit through.