Heater Box for PTC element
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple box with lid sized for a 77mm x 62mm x 6mm aluminum PTC heater element (e.g.…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 474
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Simple box with lid sized for a 77mm x 62mm x 6mm aluminum PTC heater element (e.g. https://www.aliexpress.com/item/1PCS-PTC-Thermostat-Aluminum-Heating-Element-Heater-Plate-60W-AC-DC-12V-180-Degree-Incubator-Dehumidification/32812440130.html)
Since I needed to go above 60°C, I cast mine from concrete (and printed the strain relief with XT). Files for the mold are included (I only needed one so I printed it from PLA as a single use mold).
If you want to use the cable guide, you need to put a 40x20x10mm spacer into the inner part of the mold (I used a block of Teflon). M3 nuts, M3 screws and small zipties are needed for the strain relief. Drill a 3mm hole through the base to attach the relief to the box with an M3 screw.
I designed two vial holders for this: https://www.thingiverse.com/thing:2891050
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 2
No
Supports:
No
0.2
Infill:
20%
Category: Tools