Ver. 2 - Tablet Holder for Exerpeutic Folding Exercise Bike
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Way more comfortable viewing angle than my 1st version, as this one sits higher up.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The tablet sits in the the tray section where the upper part of the tablet is supported against the padded handlebars. Shown in the 1st photo is my 10 inch tablet in the landscape position. It is super stable. Portrait position shown in the last photo. Also shown is my smaller Kindle reader.
Printing: It's one piece. Using the stl file, you need to rotate it 114 degrees (y-axis) on the print bed, as shown. (I had massive stringing for some reason as seen in the photo. Ugh.) I used a small organic support for the hole on the tray but may not be necessary.
There are 2 different files for the holder. My tablet thickness without a cover is 8mm so I printed the 10mm wide tray. I've included a 16mm wide tray file if you have a thicker tablet or cover. I haven't printed it but I imagine it should work.
Installing: As shown in the photos, I made a loop with blue tape, sticky side out, and then just stuck the holder on top of the bike's display module. It's secure, works great and won't block the battery compartment.