1 / 4
Ruger 10-22 M1 Carbine mag storage box — zdjęcie 1
1 / 4

Ruger 10-22 M1 Carbine mag storage box

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A box to put BX-1 mags in - with or without extensions

Ocena
0 / 5
Polubienia
17
Pobrania
67
Wydruki
0
Wyświetlenia
642
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This box is for Ruger 10-22 BX-1 magazines with M1 Carbine mag extensions.  This box will hold either one tray with 6 mags with extensions OR two trays with 6 each unmodified BX-1 Mags (this was not my main purpose - so they may touch each other).

There are two version of the lid.  One lid just says Ruger 10/22 on the ends.  The other lid says that and also says on the front: Ruger 10/22 M1 Carbine.  Pick one lid.  Print two of the latches.

I printed the box in NAGA PLA Plus Coffee and brown using a .15 layer height.  The tray was printed in Duramic PLA Plus black with a .20 layer height.  You will need supports on the ends of the tray part only.  

To assemble use six M3-30mm screws.  They go from the outside in and should make their own threads.  Don't over tighten them.

I didn't use the seal, but it should be printed in TPU if you make it.

Thanks to Whity and iv for the originals I modified for this.

 

Tagi