Lulzbot Taz 5 Speed Idler arm & Latch for Greg Wade extruders
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have thick fingers, so switching filament quickly can be difficult with the standard idler arm and latch. I also…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 198
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I have thick fingers, so switching filament quickly can be difficult with the standard idler arm and latch.
I also found that the idler arm wore a lot at the point where the filament first came through, so I made it into a funnel shape to improve the life of the idler arm. I also made the point where the filament went through a funnel shape to reduce wear on the idler arm. The funnel in the arm also helps change filament, guiding stiff 2.85 filament into the hot end.
I also put a tab on the side to quickly open and close the idler arm.
You can now open and close the head quickly with one hand, which is great for when you want to quickly change filament colors.
When combined these two are an improvement on the factory printed idler arms and latches.
Print Settings
Printer Brand:
LulzBot
Printer:
TAZ 5
Doesn't Matter
Supports:
Doesn't Matter
0.3
Infill:
5 -10%
Notes:
Make sure the holes are clear, process as needed.
Post-Printing
Break any sharp edges.
How I Designed This
This was a TinkerCAD hack
Category: 3D Printer Accessories