Tie Fighter Interceptor Kit Card
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
TIE Interceptor Kit Card. This model was featured on The 3D Printing Nerd.
- Ocena
- 4,869 / 5
- Polubienia
- 2065
- Pobrania
- 7007
- Wydruki
- 126
- Wyświetlenia
- 23 017
- Oceny
- 84
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial
This model was featured on The 3D Printing Nerd
We love the Star Wars Kit Cards by benzz88 Edabot Nakozen and delman83
After designing the millennium falcon kit card, I thought I would try to design a tie interceptor to go with the other star wars kit cards we've printed for his office.
Make sure to check out:
My Millennium Falcon Kit Card
Tie Fighter Ornament by Edabot
This was made to fit when printed on my homemade hypercube300 printer which is not the highest precision printer in the world, so you may have to adjust the holes, or use a little glue depending on how dialed in your printer is. Adjusting the z-scale slightly up or down without changing the x & y scale can help as well.
There are two versions included. One with a ring for hanging, or using as an ornament, and one without a ring.
Printed card is 120mm X 120mm to fit on most printers.
Assembled Model is roughly 82mm X 63mm X 50mm.
Print Settings
Printer:
Hypercube300
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
25%
Filament: Hatchbox PLA Gray
Notes:
Example is printed at 0.2 layer height, but some of my earlier tests seemed to fit a little better with 0.12 layer heights, so your mileage may vary.
Category: Vehicles