Sand Screw for Beach umbrella - 25mm Shaft
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Updated to v3, earlier versions had some mistakes in them. This is the sand screw. Designed for the beach umbrella…
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 130
- Wydruki
- 2
- Wyświetlenia
- 1026
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Updated to v3, earlier versions had some mistakes in them.
This is the sand screw. Designed for the beach umbrella with 25 mm diameter shaft.
Supplies for 25 mm:
2 M4x30 screws 1 M3x40 screw 2 M4 locking nuts 1 M3 locking nut 3D printer with rigid, e.g. PETG plastic
I recommend the following settings for max strength:
0.3 layer height
Wall Line Count = 6
Top & Bottom layers = 6
Nozzel Temp = 235c
Supports = Normal & Touching Buildplate
Ignore any "not water-tight" errors from Cura, it'll print just fine.
Print Settings
Printer:
Anycubic Mega Zero
Rafts:
No
Yes
Resolution:
0.3
25%
Filament: X3D Pro PETG White
Category: Outdoor & Garden