1 / 13
Samsung Galaxy Buds 2 Pro Dock/Holder (wired & wireless)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
To hold your Buds for in a car for example.
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 93
- Wydruki
- 0
- Wyświetlenia
- 1199
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (10)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (1)Kolekcje (24)Powiązane
There are TWO versions of this one in the model section:
- Wired version, slide in and connect to a general usb c plug.
- I made this for a generic usb c plug, but they are different thickness so you might need to adjust the height of the USB C connector by padding it or cutting it down a bit so it aligns with the USB C port on the case.
- Assemble by using two zip ties to tie the connector to the dock. You can also glue of course, up to you.
- For the wireless version, I designed it for a 10 watt USB C wireless charging module from aliexpress.
- Put a bit of tape on the back of the green PCB to protect it from shortening on the graphite coil reflector.
- Put in the PCB with the tape up
- Insert the coil with the graphite down
- Slide the top over the bottom, making sure you don not pinch any wires.
- Optional: use a bit of glue or melt the plastic to fuse the rear to fixate the sliding action if you want to.
Print in PLA at your own risk, mine melted on the dashboard. Now using prusament PC-Blend.
The used wireless module from aliexpress: 1PC 10W Micro USB Wireless Charger Transmitter Module Circuit Board QI Standard Fast Charging DIY Wireless Charger Module
2023-04-29 Note: I updated the wireless version to include a better front so the dovetails arent visible.