Medium Boy (PC Case)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Major re-design of the Little Boy S computer case.
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 94
- Wydruki
- 0
- Wyświetlenia
- 1399
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Uses eight 8x2mm Magnets as that was easy for me to get.
Made to support two 140mm fans up top with the fans inside and the Arctic 280 AIO on top, may also fit other 280 AIOs with the wider top pieces.
Overall size is about 23.1L, a little bit bigger than the NR200.
GPUs that are about 130mm wide or more will need a design that has the plugs recessed or you will need a 180 adapter.
Only supports SFX PSUs.
All tolerances have been tightened up so make sure your printer prints well.
Entire case except Motherboard side and top panel if using an AIO should be fine in PLA as long as it doesn't sit in the sun.
Two front panels, one is only for magnets and the other includes a hole to put a clip for 25mm and 27mm wide fans.
Two different bottom panel types, one is flat footed and the other has indents to print TPU feet.
Three different top panel types, one for the Arctic AIOs, one that's wider around the tube part for other AIOs and a flat one for fans.
Joiner pieces would be best printed out of something like PETG, number on it is how many you need. They simply get hammered in with a drop of super glue.
If you have SSDs they should be fine double sided taped to the back wall of the case.
FOLLOW INTRUCTIONS FOR LITTLE BOY S CASE ON HOW TO PUT TOGETHER!