mini drawers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Storage drawers for small items
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 60
- Wydruki
- 1
- Wyświetlenia
- 549
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Small storage drawers for screws, fuses, drill bits etc. Approx 80w x 80h x 80d mm (1 drawer), 80 x 35 x 80mm (2 drawer), and 35 x 35 x 80mm (4 drawer system). All single, 2 & 4 drawers have a split drawer system (see files) for more organisation.
screw holes at the rear of drawer holders to attach to a wooden base (if needed). This is an edited STL, with >20% reduction in material use by implementing ellipse cut outs and middle separator from the originals.
Supports only required for drawers (under the handles if printed flat).
Drawer holders don't need supports, you may get stringing between the ellipse if your retraction settings aren't nailed down, but a minor inconvenience otherwise. Print these base down.
No raft required anywhere.
* NOTE * I DIDN'T MAKE THIS, I EDITED SOMEONE ELSES, BUT I CAN'T FIND IT! IF THIS IS YOU, LET ME KNOW & I'LL EDIT THIS TO LINK YOUR DESIGN IN.
* UPDATE *
I've added a folder with reduced files in. 20%+ reduction in filament. Print the holders upright, with 80 degree overhang support (ie. only the very middle of circles are supported). Drawers themselves have been reduced by 0.5mm all around, and 1mm at the front. Still very sturdy.