PORTAL COMPANION CUBE COASTER HOLDER
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple coaster holder.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 24
- Wydruki
- 1
- Wyświetlenia
- 183
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I downloaded the coaster model from Printables. They also include a holder, but I was looking to save a little time with multi-colour printing on our Bambu.
Here's the original coaster models:
https://www.printables.com/model/232088-portal-companion-cube-coasters-and-holder
Originally I made a couple of these coasters in resin, without changing any scales and whatnot.
The coasters in the images have been tweaked for my holder, and should fit any 'Companion Cube Coaster' design, as long as you size the coaster to 100mm width.
The original coasters were 7.5mm high, but I wanted to save a chunk of printing time, so I reduced the height to 4mm. I'm used rubber pads for my prints (pads with a 2.5mm height), so the holder is able to hold 4 coasters easily. So size your coasters appropriately.
For multi-colour printing, I've included a 3mf file, and I've printed this on a Bambu P1S. I'm assuming my settings transfer over with the file.
Happy Printing!