Wider 1.9" 12mm hex RC beadlock rims
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of the neat 1.9" 12mm hex RC rims that use an internal beadlock design to clamp the tire to the rim.
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 130
- Wydruki
- 0
- Wyświetlenia
- 810
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A remix of the neat 1.9" 12mm hex RC rims that use an internal beadlock design to clamp the tire to the rim.
Included are only my favorite bead ring as you can reuse the original ones if need be (go check out the original design, it's great) plus the thicker internal ring.
How I Designed This
Hub Position Adjusted
I adjusted the hub center position to be further inside the well and enlarged it by 2% as my aluminum hexes just didn't fit when printed out of PLA.
Adjusted hub position visible on the wireframe
Deeper screw holes
The screw holes were extended to accommodate 20mm M2 screws - for strength, plus I had plenty of those.
Highlighted deeper screw holes on the wireframe image
Wider ring
To make my tires fit better, the internal ring is now 5mm wider and the rim 4mm. That fixes tire retention and makes it 26mm wide at the thinnest part.
Adjusted top edge highlighted on the wireframe image
Category: R/C Vehicles