OpenRC - F1 Workbench (2-in-1 construction)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Thanks to Daniel Norée (http://www.thingiverse.com/barspin/) i've printed my own Open RC F1 car and of course wrecks…
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 96
- Wydruki
- 2
- Wyświetlenia
- 581
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Thanks to Daniel Norée (http://www.thingiverse.com/barspin/) i've printed my own Open RC F1 car and of course wrecks it all the time because I'm a bad driver.
There for i created this 2-in-1 workbench that lets you put your car in a good position if you need to either screw or put in electronics, without damaging small accessories like the mirrors and camera in the model.
The design goes together and works both normally and upside down.
Print Settings
Printer:
Flashforge Dreamer
Rafts:
Doesn't Matter
No
Resolution:
0.25
10%
Notes:
Print the following:
1 A-side
1 B-side
3x Connector A
2x Connector B
Post-Printing
Filing might be needed! Super-glue the parts for extra stability.
The "upright" position should snap around the flat chassi-part. Use grinding/filing if needed.
How I Designed This
Category: R/C Vehicles