Window Blind Rail Handle (Home Depot Home Decorations Blinds)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pull Handle for the Home Depot Home Decorations Cordless Blinds
- Ocena
- 4,5 / 5
- Polubienia
- 11
- Pobrania
- 100
- Wydruki
- 1
- Wyświetlenia
- 426
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
We replaced our bedroom blinds with Home Depot's Home Decorations Cordless Blinds. Our previous blinds had pull handles that kept dirt and oil from our hands off the blinds. The new blinds did not come with pull handles. This simple easy-to-print handle mounts to the bottom rail of the blinds. These will fit blinds that have a base rail size of approximately 40mm deep by 33 mm tall (1.6" deep x 1.3" tall). I might consider adding other sizes if you provide me via comments with the exact bottom rail measurement.
I printed with Translucent (Clear) PETG. I printed a few in white PLA but the white of the PLA didn't match the white of the blinds. The white PLA didn't look bad however the Translucent filament looked better. I print with 4 wall loops for strength and a layer height of 0.16mm. I was able to print without supports however supports will improve the results. To install simply spread the handle enough to place over the rail then center on the rail. For blinds 48 inches wide or greater you may want 2 handles; one near each end of the blind.