Technivorm Moccamaster Drip-Stop Plug
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
Our ten year old Technivorm Moccamaster Clubline coffee maker is still working great but the drip-stop tab tends to drop down by itself causing overflow in the filter. This is a plug that will keep it in the open position. If you want to use the drip stop like intended you can just temporarily remove the plug and slide it down.
This printed plug follows the curvature of the filter holder and it was designed to blend in with the original design so if you print it in black plastic it will hardly be noticeable.
It should fit all Moccamaster Classic coffee makers that use this style of filter holder.
Support
All my designs and mods on Printables are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :)
https://www.paypal.me/humebeamengineering
Print Settings
Printer:
QIDI Tech X-Max
Rafts:
No
Supports:
No
Resolution:
0.08 mm
Infill:
40%
Filament: Clas Ohlson ABS Black
Notes:
Print it in the direction I have set it. Supports are not needed.
I printed in a layer height of only 0.08 mm but 0.2 mm is fine too.
Post-Printing
Without plug installed:
Plug installed. You can install it both ways, use whatever you think looks best.