Hobbyking Berserker Front Body Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement for the front body mounts on the Berserker 1/8 truggy. I kept breaking them quicker than I could…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 84
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a replacement for the front body mounts on the Berserker 1/8 truggy. I kept breaking them quicker than I could get replacements.
Print Settings
Printer Brand:
FlashForge
Printer:
Dreamer
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
100
Notes:
Print with the flat side on the bed. No supports or rafts should be needed.
Post-Printing
Break off the two flat pieces near where the pins go. These are only there to help keep the ends of the post from warping while printing.
The flat side of the piece goes towards the front of the car. The eye at the top rear is to mount a Diatone FPV camera if desired.
Category: R/C Vehicles