1 / 11
80's Toy Store Radio Controlled RC Car like Turbo Hopper — zdjęcie 1
1 / 11

80's Toy Store Radio Controlled RC Car like Turbo Hopper

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I used to love the RC cars from Children's Palace and Toys R Us when I was a kid, and as a young adult and as an old…

Ocena
0 / 5
Polubienia
30
Pobrania
123
Wydruki
0
Wyświetlenia
1407
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution

I used to love the RC cars from Children's Palace and Toys R Us when I was a kid, and as a young adult and as an old man. It seemed to be a good project to use to learn about Fusion 360 and how to use my new 3D printer.

This is my attempt at recreating the same sort of car that I cut lawns for money to buy in the 80's. It is almost entirely 3D printed parts. It works well overall, I think the tires aren't as grippy as non 3D printed parts and I believe I have too much power in it.

I've divided the parts into sections and put the various sections into zip files. The body.stl file is also included in the body.zip file.

Needed to complete:

Electronics:

RC radio and receiver

20mm motor, 16mm mounting holes

Electronic speed control

Mini servo

Battery – compartment is small, check size

Antenna tube

Mechanical:

Losi Mini 8ight spur gear 62 tooth Part LOSB1922

48p or .5mod pinion 13t or smaller appropriate for your motor

RC body pin/clip

4 – 6x10x3mm bearings for gearbox

4 – 3x6x2.5mm bearings for front wheels

1.4mm music wire for tie rods and drive axle pin

3 - suspension springs – I used Part 88018 from Menards 1 for each front and 1 split in half for rear.

2 – 3x25mm screws for rear axle – goes through bearings to strengthen axle

Assorted other 3mm, 2.5mm, 2mm and 1.5mm screws

Print Settings

Printer:

Flashforge Dreamer

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

.1 and .2

Infill:

10% + 100%


Notes:

Body is PLA, printed at .1 with 100% infill
Tires are Ninjaflex, printed at .2 and 10% infill

Rest of parts are PETG, printed at .1 and 100% infill

Print the parts in an orientation that makes most sense for strength, as an example the rear axle should be printed horizontally.

Use 25mm bolts/screws to hold on the rear wheels so that they go into the gearbox past the outer bearing. This and printing the axle horizontally seems to add greatly to the strength of the rear end.

Post-Printing

Clean off supports as needed. Smooth parts such as shocks that fit together with sandpaper. Careful with screws, they thread the parts needed. Use a 10mm long piece of the 1.4mm music wire as a key in the rear axle (there is a hole) to interlock with the spur adapter.

Category: R/C Vehicles

Tagi