Drying compartment adaptor for Rosewill food dehydrator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed and printed this in 2019, but it was a poor design, and I rarely needed to use it. This is version 2.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I designed and printed this in 2019, but it was a poor design, and I rarely required it. I printed it with PLA, not thinking that the temperature for dehydrating PETG is too hot an environment for PLA. After printing all the parts for the MK3S to MK3.9 upgrade with PETG, the spool of black had issues with adhesion and quality of print. I used the dehydrator to solve that issue and again I realized that the previous design and print were poor, so I started from scratch with version 2. I am pleased with how it turned out. It is sturdy and fits well.
I cut off the center ring that protruded above the tray surface so that the spool would sit on the tray surface. Once the adaptor is installed, add the lid and dry your spool. You can dry silica gel packets along with the spool if you add another tray with the lid. You can dry an additional spool by adding another tray, adaptor, and lid.
I printed it on my newly upgraded printer using PETG with 0.3mm layer height and 2 perimeters on a smooth sheet with a glue stick since the model is tall and narrow and would probably have warping issues. I added a 3mf file that shows the arrangement to be able to print two parts.
Hardware is:
4 screws - M3 x 25
4 hex nuts - M3
Rosewill Food Dehydrator model RHFD-15001 or similar
As usual, I have included the FreeCAD file and the model is parametric if it needs to be adjusted for your dehydrator.