1 / 5
MK4 xBuddy HSW - Honeycomb Storage Wall
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Piece of HSW to mount to the xBuddy box of your Original Prusa MK4. To ergonomically store tools right where needed.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 630
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (30)Powiązane
Curiously, the xBuddy cover screw holes are exactly 6 honeycombs apart. So, why not add an adapted HSW to the xBuddy Box to store the most frequently used tools?
- Structural integrity is not great when only mounted using the provided M3 countersunk screws. You could attach this HSW module to the HSW you got mounted to the wall using this 90° corner join countersink. Or/and add rubber feet to the bottom to support against down forces.
- It's advisable to equip the wall with the necessary countersunks for your layout prior to mounting it, to prevent putting too much force on the tiny M3 screws in the xBuddy cover.
- The adapted countersink has a very tight M3 cutout on purpose. This helps minimize lateral movement of the wall. The M3 screw will fit if the part is printed precisely. You might need to apply reasonable force to screw it in. Be cautious not to over-tighten the xBuddy screw hole threads.
Assembly:
- Acquire two M3x10 screws. (There are some spares in the MK4 Kit.)
- Place the two provided M3 countersinks into the protruding combs facing the printer.
- Decide on your layout and insert the necessary countersinks.
- Remove the original M3x6 screws.
- Attach the countersinks and wall to the xBuddy cover using the M3x10 screws.