1/2EMT / 18mm Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spool holders for 18mm rods or 1/2" EMT. Made for the (Un)Original Prusa Drybox
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 65
- Wydruki
- 5
- Wyświetlenia
- 412
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Spool holders for 18mm rods or 1/2" EMT. Designed for the (Un)Original Prusa Dry Box but could have many other uses.
Holders clamp on the bearings on the inner race and offer clearance for the outer race to eliminate any drag on the bearings.
No supports needed. When printing the Mid Plates and End Plates, make sure that the bearing cavity with the boss is facing up.
The locking screw for the rods should only be tightened finger tight. Using tools may break the spool holder.
BOM for End Holders
1x Left or Right End Plate STL
1x Side Plate
2x Single Pin STL
2x 608 Bearings
5x M3x10mm screws
1xM3 square nut
BOM for Middle Holders
1x Mid Plate STL
2x Side Plate STL
2x Double Pin STL
4x 608 Bearings
5x M3x10mm screws
1xM3 square nut
Complete BOM for (Un)Original Prusa Dry Bom
5x Mid Plate STL
1x Left End Plate STL
1x Right End Plate STL
12x Side Plate STL
10x Double Pin STL
4x Single Pin STL
24x 608 Bearings
35x M3x10mm Screws
6x M3 square Nuts