15-22 M4 stock QD sling attachment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use this part to attach a Magpul QD sling cup to an M&P 15-22 or generic M4 stock
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 902
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Use this to mount a Magpul QD cup on an M&P 15-22 with an M4 stock--it also fits some (many?) other M4 stocks, and M4 stocks with a saddle cheek rest installed. I wouldn't go to war with this but it's perfectly adequate for range use.
Tested with:
M&P 15-22 M4 stock (late 2019 manufacture)
Tapco M4 stock
Other M4 stocks with a SST saddle adapter (shorter model)
It should work with any M4 stock that has a little bit of clearance above the sling slot. See pictures for what will and won't work. Installation _may_ require slight relieving of either the sling strap slot or the extra plastic surrounding the tube above the slot. This was not required on the stocks I tested, but it was close.
You need to purchase the Magpul QD cup to use this model:
https://magpul.com/sling-mount-kit-type-1.html?mp_global_color=118
You want the type 1. Type 2 does not come with the nut and screws. The model here will capture the hex nut and hold it on the other side of the sling slot.
Use the nut and shortest screw from the kit. The kit comes with a 10-24 jam nut, which is smaller than a "standard" 10-24 nut (the latter will not fit in this model). If you use the shorter model with a saddle cheek rest, use the second longest screw.
You can print in any orientation but it will require supports. I think printing with the opening for the hex nut facing the build plate is the best compromise. You want a nice flat surface bearing on the stock, and for the nut to tighten against. 100% infill, 0.2 layer height. I recommend printing outside walls first for good dimensional accuracy.
Install instructions:
- Remove the magazine and unload the rifle. Double check--you don't want to pull an Alec Baldwin here.
- Insert the hex nut from the kit into the printed model. You can thread the nut onto one of the longer screws to push or pull it fully into place.
- Put the screw into the base of the QD cup, and stick it on the end of an allen wrench. Keep this wrench/cup assembly in one hand.
- On the opposite side of where you want to the sling to attach, fit the raised part of the model into the sling slot on the stock.
- With your other hand, insert the screw into the hole in the model and tighten the screw. Don't overtighten--the screw has threadlocker pre-applied.