1 / 3
V1 -- Nema 17 Peristaltic Pump / Water Pump / measuring Pump — zdjęcie 1
1 / 3

V1 -- Nema 17 Peristaltic Pump / Water Pump / measuring Pump

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Peristaltic Pump. Allows you to pump specific fluids without ever touching anything besides the tube itself.

Ocena
4,2 / 5
Polubienia
422
Pobrania
1018
Wydruki
7
Wyświetlenia
11 576
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Version 2 out now in a remix --->

All you need is a Nema 17 motor, 4 x 608 bearings and some 8mm plastic Tubing (Soft tube needed). You will also need some 16mm M3 screws to attach the pump assembly to the stepper motor.  Of course the rest of the electronics to power the stepper motor are also needed. Also it might not be to bad of an idea to glue the tube into place so that it doesnt slip away. 

I recommend printing the part that holds the bearings in place with 60% infill. 

For  the housing 15% should definitely be enough. 

 

Part list:

  • 5x 608 bearing

  • 4x 16mm M3 screw

  • 4x 15-30mm M3 screw 

  • 8mm tubing (slightly smaller or bigger tubes will also work, if the spacer is correctly modified)

  • Nema 17 stepper motor

  • Hardware and software to control the stepper motor 


UPDATE 09.04.24: I updated the pressfit of the bearing as somebody recommended this in the comments

UPDATE 10.01.26: Version 2 files updated