Tamagotchi Care Robot - With Kill Mode
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Check the build video on YouTube: https://youtu.be/UO_E9Lg-0vo
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 1059
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Code: https://github.com/JensMakerAdventures/Tamagotchi-Incubator
Can be printed without supports, I used PLA. If you use black material maybe you don't need a shield in the back. I did need this because the backside reflected light into the screen making it hard to do vision.
As the models are, the camera might not align with the tamagotchi so you need to wedge some material in between.
I used m2 threaded inserts, bolts and nuts for this project.
Main parts:
Plexiglass 3mm thickness
Raspberry Pi 3
3.5inch RPi LCD, 480x320, IPS, Resistive Touchscreen
Raspberry Pi Camera Module 2 - 8MP
LISIPAROI White LED ring for RPi Camera
Raspberry Pi GPIO Edge connector(2x40-pins) (for splitting GPIO)
DSI/CSI Flex cable for Raspberry Pi - 61cm (could have been way shorter)
40 pins Rainbow GPIO cable extender male/female - 10cm (I had to use dupont since this was sold out at the time)
3x SG90 servo
Some tiewraps for cable management
Dupont connectors for Raspberry Pi <-> Light Ring
I2C PCA9685 12-Bit 16 channel PWM/Servo Driver board