6g72 Timing Belt Tension Tool (parametric)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two-pin tool to set tension on timing belt with 1/4" torque wrench
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 65
- Wydruki
- 0
- Wyświetlenia
- 553
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE: this print did not have the strength to hold the pulley in place while torquing the ~40+Nm spec on the pulley bolt with the posted ¼" size as the square rounded out. A remix to allow 3/8 might do the trick. The body support and m3 screws did not seem to be a problem. Overall, the special tool is probably worth buying if you're getting into a timing service on your 6g72
***IGNORE*** Save yourself the $50 on this job-specific tool. As the spec is only ~5Nm there is no reason a printed tool can't do the job. ***IGNORE***
BOM:
- Filament
- (2) m3 flat head cap screws - STL file is sized for 20mm screws. Edit the screw size in F3d file if you have screws of another length. Minimum will be socket depth +~10mm
I printed at ~60% infill with several walls and 0.6mm nozzle. Have not yet tested beyond fit. Posted model has deeper countersunk holes than shown in photos.