Battery Terminal Cover for M8 hex nut terminals - LiFePO4 batteries
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This battery terminal cover design allows its use without turning the hex nut (i.e. changing its torque) underneath it.
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 286
- Wydruki
- 1
- Wyświetlenia
- 1474
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
IMPORTANT NOTE: If your battery's terminal(s) / terminal wire(s) get hot you need to ensure the printing material you use for this design will suffice. The included GCODE files assume the use of PTEG.
This battery terminal cover is a two part design allowing for it to be used without turning the hex nut (i.e. changing its torque) underneath it.
While this model was specifically designed for a Li Time LiFePO4 battery, it should be useable on other batteries which also have a M8 hex nut as their terminal.
The side opening has been designed to accommodate a 4/0 cable plus a smaller a gauge accessory wire (as is sometimes used on the positive terminal).
Of note, a standard M8 hex nut normally has a side to side width of between 13 and 12.77 mm. The top print is designed with a 12.7 mm side to side width for a very tight fit - helping to ensure it doesn't pop off when used in a mobile environment.
Included are the .stl, PRUSA, GCODE, and Fusion 360 source files for this design.