1 / 4
Meshtastic TTGO T-Beam Case - SciFi
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stylish Sci-Fi inspired case for your Meshtastic radio
- Ocena
- 4,929 / 5
- Polubienia
- 449
- Pobrania
- 1928
- Wydruki
- 21
- Wyświetlenia
- 13 850
- Oceny
- 14
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (9)Wydruki i komentarze (Wydruki: 21) (Komentarze: 29)Remiksy (3)Kolekcje (488)Powiązane
This is my attempt at a case for the TTGO T-Beam. I wanted something with a different style than the rugged and utilitarian cases out there. This is inspired by Portal, Sci-Fi concept art, and a little bit of Cassette Futurism.
Assembly Instructions
Hardware
- 4x M2 Heat-Set Threaded Inserts
- 2x M3 Heat-Set Threaded Inserts
- 4x M2x8 Screws
- 2x M3x8 Screws
Printed Parts
Print one of each of the printed parts. Support material should not be required for any of them, but good part cooling will help. ABS is recommended if it will me used in a hot place, like on a car's dashboard. If printing with ABS, some parts may need a brim to prevent warping.
This is the pictured color scheme
Primary Color (Black)
- Body
- Back Cover Insert
- Front Panel Insert
Secondary Color (White)
- Antenna Cover
- Back Cover
- Front Panel
Accent Color (Blue)
- Buttons
Translucent
- GPS LED
- Status LED
Steps
- Insert heated inserts.
- Glue LED pipes into Front Panel Insert.
- Slide Buttons into slot in Body.
- Put Front Panel Insert over top of T-Beam.
- Put T-Beam and Front Panel Insert on front of Body. Screw down with M2 screws.
- Put on Front Panel and screw to Body with M3 screws.
- Press Antenna Cover onto antenna connector on T-Beam.
- Snap Back Cover Insert into Back Panel.
- Snap Back Panel onto the back of Body.