Inventum GF552HL airfryer timer knob
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement knop for the timer part of an Inventum GF552HL airfryer (2018).
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 300
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Original knob started "slipping" when rotated, making it very hard to activate or shut off the airfryer. Decided to print a replacement if I could. Kudos to @Mich21050_518668 for sharing the f3d file so I could base my version off of that - see differences.
Printed in PLA, with 20% gyroid infill, 6 wall lines (trying to make the stem as sturdy as I could, as that is the weakest part - will see how long this holds! If you put the seam on the side where the indicator is, it is almost like an extra indicator stripe on the side ;-)
Knob slides on a bit difficult (also because in my case the timer unit is a bit loose in the housing, sliding to the back when pushing the knob on), but adding a tiny bit of “silicon grease” to the inside of the knob stem and the metal rod where it is pushed on helped.