Lower cord winder hook for Shark Rotator vacuum
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The lower hook for winding the cord on my Shark Rotator vacuum (Model UV560 31, according to the label) broke, leaving…
- Ocena
- 5 / 5
- Polubienia
- 1
- Pobrania
- 76
- Wydruki
- 1
- Wyświetlenia
- 625
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
The lower hook for winding the cord on my Shark Rotator vacuum (Model UV560 31, according to the label) broke, leaving the cord a tangled mess. This is a rough replacement for the original part. It's not a perfect fit - the contours on the vacuum are pretty challenging to model accurately - but it fits and works. I also hope that it's a bit stronger than the original.
STEP file provided in case you need to make adjustments for your specific printer or vacuum.
Print Settings
Printer:
Geeetech A10
Rafts:
No
Yes
Infill:
25
Filament:
Atomic PETG Gray
Notes:
I recommend printing the part on its side (see the images) to maximize strength. The diagonal orientation results in a decent compromise of strength in various directions and has worked well for me so far. Give the part a few extra perimeters - I used 5. Support from build plate only.
When post-processing, I recommend drilling out the screw holes slightly (with a ~3mm bit) to prevent cracking.I think most materials would be fine - I chose PETG because that was the filament I had available in gray.
Category: Replacement Parts