Holder for EV-Charger Cable Type2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Needed to find a good rest for the charger cable. Took main idea from Printables and re-designed from scratch.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 782
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I admit that the base receiver for the plug of the ev-charger cable type 2 came from https://www.printables.com/de/@Dani_255908 Thanks to Dani!
As there were some major inconsistencies in the files after TinkerCad import I decided to reverse engineer the holder and base plate from scratch.
I wanted to have the holder rest somewhere at my IBC (rain water container), which is sitting on top of a bulk of paving stones. Also in future I can add some cable management so that cables are up in the air, not reason for stumbling.
I made the whole design of 7 stl-parts. Base plate, two lateral hooks attached to the IBC rods (lateral parts printed lying on the buildpkate for better stability reasons. A locking catch so that the plate is securely fastened, then finally the main receiver with the locking catch and cover. Some hex-screws M4 and a ball-pen spring, Torx screws, M3x24mm dowel pin and M4 heat inserts are all you need.
Printed on my MK4 and Voron 2.4(350). Used PETG for the parts.
Enjoy electric driving!
Explore my other Printables: https://www.printables.com/de/@Tritschi