1 / 2
Messerblock mit Station für Horl Rollschleifer / Knive block with station for Horl Rollscheifer — zdjęcie 1
1 / 2

Messerblock mit Station für Horl Rollschleifer / Knive block with station for Horl Rollscheifer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dies ist ein Messerblock mit Station für den Rollschleifer von Horl 1993 (https://www.horl-1993.com/) inkl. des…

Ocena
0 / 5
Polubienia
5
Pobrania
20
Wydruki
0
Wyświetlenia
747
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

Dies ist ein Messerblock mit Station für den Rollschleifer von Horl 1993 (https://www.horl-1993.com/) inkl. des Abziehleders. Die Messer werden durch Schaschlikspieße aufrecht gehalten. Auf dem Bild sind ca. 1600 Spieße mit 20 cm Länge und 3 mm Durchmesser verwendet worden.

This is a knive block with a station for the Horl Rollschleifer (https://www.horl-1993.com/) including the leather strip for removing the chips The knives are held in an upright position by kebab skewers. You'll need approx. 1600 skewers with a length of 20 cm and a diameter of 3 mm.

Print Settings

Printer Brand:

Anycubic

Printer:

All-metal Mega

Rafts:

No

Supports:

No

Resolution:

0,3 mm

Infill:

10%


Filament:

Das Filament PLA Black / White

Notes:

Für den Zweifarbdruck wie auf dem Bild, muss man das FIlament bei einer Schichthöhe von 0,3 mm bei Schichtnummer 188 tauschen.

If you use a layer height of 0,3 mm and want a two-coloured print like in the picture, you will have to change the filament at layer 188.

Post-Printing

Nach dem Druck nur noch die Schaschlikspieße in den Messerblock stellen und dann die Messer hineinstecken bzw. den Rollschleifer hineinstellen.

Add the kebab skewers, than the knives and the Rollschleifer.

Category: Kitchen & Dining

Tagi