Garden Strawberry Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A strawberry plant support to keep your delicious strawberries off the ground
- Ocena
- 5 / 5
- Polubienia
- 150
- Pobrania
- 396
- Wydruki
- 3
- Wyświetlenia
- 1935
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Last year the bugs were able eat a bunch of my strawberries, not this year! While preparing the greenhouse for spring planting, I was surprised to find that a few of my strawberry plants were already flowering. Last year I tried a net trellis with some success, however the bugs still got too many of the delicious strawberries. I wanted to try something different this year and decided to make some strawberry supports.
I placed these on plants that had been planted in previous years, it should be easier to place them with new plants.
I recommend letting the build plate cool for a few minutes before attempting to remove to prevent accidentally damaging the print. PETG will provide better protection against UV rays. I printed these in PLA this year and will replace them next year if needed.
Sizes
Full size
- 224mm W x 224mm D x 80mm H
- 8.8" W x 8.8" D x 3.1"H
- Center Diameter - 80mm (8.8")
Mini Size
- 174mm W x 174mm D x 80mm H
- 6.8" W x 6.8" D x 3.1" H
- Center Diameter - 62.4mm (2.5")