Dead Air Suppressor holder (remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of a single holder to a multi suppressor holder for Dead Air.
- Ocena
- 4 / 5
- Polubienia
- 11
- Pobrania
- 138
- Wydruki
- 2
- Wyświetlenia
- 805
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
I printed the 52mm file from the original creator and found it was not what I needed.
I resized the model to fit several Dead Air Suppressors. I then merged each holder to combine them into two sets of 3.
These holders fit the following: Dead Air Mask, Ghost, Mojave 9, Sandman-S, Primal, Wolfman.
The original creator intended to mount the holders with magnets in the safe. I was not able to mount this way, so I added ears to screw into instead.
Use supports, Tree slim, critical regions only.
Printed with PolyLite PLA Pro, black
I did a 5mm outer brim, but you may not need it.
Printed on a Bambu X1C. .20mm, or .16 for nozzle. 15% Rectilinear for infill.
The 3mf file has models with and without the side tabs.