Replacement FasTrack Switch Stand (and optionally Lever)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Lionel Fastrack manual switches have a weak design for the switch stand and lever. It would last a 10 year old kid…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 693
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- GNU General Public License v2.0
The Lionel Fastrack manual switches have a weak design for the switch stand and lever. It would last a 10 year old kid about 3 minutes before it is broken.
I have two switches, both broken. I did order replacement stand and lever for them directly from Lionel :
Item 17 6102017084 STAND / SIGNAL LEVER / FASTRACK MANUAL SWITCH
Item 8 6102017094 RED SIGNAL LEVER / FASTRACK MANUAL SWITCH
When I got them, I promptly destroyed one of the stands trying to get the feet into
the holes on the roadbed.
So I decided to design a replacement switch stand myself. (Note that I tried to design a replacement lever as well but its small geometries were beyond my abilities to produce.)
Attached is the OpenSCAD code to create the stand. The code also attempts to create a lever but, as I said, I was not successful at that. I used the PrusaSlicer and created PLA gcode files (all attached). If you think you need something stronger, you might want to reslice for ABS. The gcode file is sliced for a Prusa i3 MK2s.
The switch stand uses supports which need to be cleaned off. The stand fits snugly into the roadbed holes. I did not use the two small screws to hold it in place. You may need to run a small drill bit though the holes in the stand for the lever.
Print Settings
Printer:
Prusa i3 MK2s
Rafts:
Doesn't Matter
Yes
Category: Vehicles