Locksport-Specific Plug Followers - v3 - 8/31/2024
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Split/Solid, Split/Split, and segmented plug followers.
- Ocena
- 4,8 / 5
- Polubienia
- 45
- Pobrania
- 265
- Wydruki
- 4
- Wyświetlenia
- 997
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Here are three sets of followers designed with Locksport in mind. One set is great for gutting on camera and one is just generally good for lock assembly/disassembly. There is also a set of segmented followers for dual Euro cylinders.
The three designs are as follows:
Split/Split - Choose this for gutting locks that have driver pins in specific orientations. Gutting these locks on camera (for LPU) requires that you show the driver pin orientation as it comes out of its chamber. The split end is great for this. And being double ended means you can use the split feature on both sides of the lock as your gutting, without having to try and rotate the follower around.
Split/Solid - Just your basic plug follower. Great for assembly and disassembly of locks. Split tail on one side and solid on the opposite.
Segmented - Stubby followers (10mm in length) in the standard 4 diameters (listed below).
The Split/Split and Split/Solid followers are 70mm in length. The Segmented followers are 10mm in length. Within each set there are 4 different diameters: 10mm, 12.5mm, 12.8mm, and 14mm.
I recommend you print with the following settings:
- Raft on
- Supports (for Split/Split only)
- Infill at least 15%
Update V3 - 8/31/2024
- Added segmented followers. Same four diameters as the standard followers, but 10mm length segments.