SAS PLA Temp Tower
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Short & Sweet PLA Temp tower
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 212
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Short & Sweet temp tower for what my PLAs typically print at on my machine. I rarely need to go over 215, and never down to 190 so I omitted everything else.
I print these in spiral/vase mode and pull each end to see where the layer adhesion works and look at the rest for visual quality. The gcode I'm adding is for my printer profile so I don't need to re-slice it Don't be afraid to re-slice and post-process the model for your machine.
You can see in my example print that 205-215 all had good adhesion (the breaks are a result of the notch in the model). 195 and 200 were too easy to pull apart. I prefer the look of 210 for this pla.