Star Wars C3PO Hueforge 220x220
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
AI-generated C3PO Image 220x220 With Frame
- Ocena
- 0 / 5
- Polubienia
- 28
- Pobrania
- 102
- Wydruki
- 0
- Wyświetlenia
- 586
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Use the latest version of Orca Slicer and load the project which, will already have the pieces on plates with the correct colors and settings.
This is done in 2 prints and then the C3PO is carefully put into the background piece. It is very tight but does fit. Suggest some glue to tack down the middle and prevent warping.
Enjoy :)
C3PO:
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA Overture Matte Black Transmission Distance: 0.1
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #28 (1.28mm) swap to Black
At layer #29 (1.32mm) swap to Red
At layer #34 (1.52mm) swap to Orange
At layer #39 (1.72mm) swap to Yellow
At layer #54 (2.32mm) swap to Jade White for the rest.
Background:
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA Overture Matte Black Transmission Distance: 0.1
PLA PolyLite Steel Grey Transmission Distance: 1
PLA BambuLab Basic Blue Transmission Distance: 4
PLA BambuLab Matte Ice Blue Transmission Distance: 3.5
PLA Elgoo Grey Transmission Distance: 2.6
PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #28 (1.28mm) swap to Black
At layer #29 (1.32mm) swap to Steel Grey
At layer #33 (1.48mm) swap to Blue
At layer #34 (1.52mm) swap to Ice Blue
At layer #41 (1.8mm) swap to Grey
At layer #43 (1.88mm) swap to Jade White for the rest.