Workmate feet big and small
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Large lower foot and smaller triangular foot for Black and Decker Workmate WM5XX. These fit well and have been on mine…
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 289
- Wydruki
- 3
- Wyświetlenia
- 888
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Large lower foot and smaller triangular foot for Black and Decker Workmate WM5XX. These fit well and have been on mine for some time now. I printed these in Rigid Ink TPU with the speed slowed to about 20mm/sec. I still get a bit of stringing on the inside but the outside finish is good and the strings can be just pulled or cut off.
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Mk2
No
Supports:
No
.2mm
Infill:
100%
Notes:
Works best with the speed slowed down to about half normal as this reduces the stringing. I use either 100% fill or many perimeters to get a solid bottom casing as they get a lot of wear. Print with the bottom of the foot to the bed and you will not need supports
Category: DIY