1 / 3
Centre Finder and Marker Tool for rods up to 110mm diam and squares up to 110mm square
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Alternative design of centre finder, uses a slot at dead centre to avoid pencil/biro offset
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 47
- Wydruki
- 1
- Wyświetlenia
- 230
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (13)Powiązane
The snag with marking a centre using a side-edge is that the line you draw is offset from the edge by half the width of the pencil lead, and that could cause a significant error. So I went with a slot whose centre is the desired line, and the pencil then sits in the centre of that slot and the middle of the pencil line is the exact line you want. Make two marks at different angles and the centre of the cross is the exact centre of the workpiece.