Percussion frog with support only in the mouth

Percussion Frog 90% infill, WITH SUPPORT, only in the mouth

Remix of the mega cool and genious percussion frog, the honor of its creation goes to its original designer.

Nevertheless, due to printing the original is not easy, I did a remix containing support which is easy to print and to remove:

In the new version of Prusa Slicer, you can easily add support manually with the brush. But it's still not that easy. So here are my .3mf-files (for the MK4, but you can change it in your PRUSA Slicer ;-).

Two versions: Original size and 200 % size.

I recommend printing the 200 % frog (with 90Proz infill) with PLA. It is realy loud and sounds very good :-).

To the smaler (origin size) frog I added a raft which is not necessary at the 200% version, except if you're printing quite fast.

Tip: To remove the support, simply "press down hard on the teeth" with pliers or a fine knife, at the top and again at the bottom if necessary - on both sides of the mouth - then the support will pop out in one piece :-). Take courage :-).

Final note: Due to the biggest compliments should go to the designer of the percussion frog

https://www.printables.com/de/model/245546-percussion-frog 

please leave also a like and/or comment there 😍,  thanks.