1 / 1
Print in Place Fleshlight Flight/ Pilot /Go Sleeve Drying Hanger — zdjęcie 1

Print in Place Fleshlight Flight/ Pilot /Go Sleeve Drying Hanger

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A print-in-place hanger to air dry the sleeves for Fleshlight "Flight", Pilot", and "Go" models.

Ocena
5 / 5
Polubienia
49
Pobrania
866
Wydruki
1
Wyświetlenia
8298
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Print Settings

I printed a few iterations, at .02 mm layer height.

The one pictured is not the final model and was printed before I decided to bulk up and smooth out the hanger portion.

Consider Your Filament

Please be careful with any 3D prints for the bedroom. FMD prints are not body-safe and should never be rubbed on the skin, put in the mouth, or inserted. The layers can hold bacteria and act like an abrasive to skin, causing friction burns, and tears to sensitive tissue.

Prints with poor adhesion/ larger layer heights will be harder to keep clean. If you have problems with adhesion the print will soak up water and any other fluids that get on it, so the best practice is to throw those as failures out.

Some rubbers and plastics will react with one another and cause each other to break down if stored together. If that happens they can start leeching toxic chemicals, and make the material porous and thus impossible to sanitize.

TPU and other flexible filaments should never be used with silicone or other synthetic rubbers.
To prevent a reaction, check that the filament you are printing with will not react with any materials it will be used or stored with.

I believe ABS and PLA are fairly non-reactive to most plastics and rubbers. Specifically, prints should be fine to use and store with silicone/ silicone-composite rubbers.

Post Processing

After printing inspect your print and remove any burrs or rough surfaces on your print that could damage your fleshlight sleeve.

Proper care of your toys helps them last longer. This hanger will help dry your sleeve(s) after rinsing and sanitizing with a toy cleaner or diluted ISO alcohol. You can either leave it hanging for a few hours to hang dry over a radiator or air vent, or hold a hair dryer on low or cold heat to speed up the dry time. Once dry, dust the sleeve with the powder from Fleshlight, or regular cornstarch and replace in it's case for future use.

Tagi